When you purchase your Axkid car seat, additional tether straps are always included to enable installation in all cars, with or without attachment loops. For Axkid Move however, there is an exception since the tether straps on the seat are different and can be attached to any car directly without the use of additional tether straps. For more detailed installation instructions please click here »

Absolutely, you can wash it in a 30-degree program on a gentle setting. Do not tumble dry.

The harness can be removed and cleaned, but not in a washing machine. What you can do is remove the harness and wash it by hand with a damp cloth and an unscented soap. The other plastic components of the car seat can be cleaned by hand as well. Important to note however is that you should not use any cleaning products containing solvents since these can have a negative impact on the plastic and thus the safety of the car seat.

All our car seats have tilt functions in the front. Try to use these first to get a better angle on the car seat, see the user manual for detailed information. If you need to tilt the car seat even more, we recommend our accessory “angle adjusting wedge“.

Here is a video of how the wedge should be used.
https://www.youtube.com/watch?v=3FRZucidWE0

Axkid car seats can be installed either with ISOFIX or with the vehicle’s seat belt, depending on the model.

ISOFIX connects the car seat directly to the vehicle’s ISOFIX anchor points and can make installation easier. Seat belt-installed car seats use the vehicle’s three-point seat belt and may offer more flexibility when choosing where to place the seat.

Always follow the installation instructions for your specific car seat and check that it is compatible with your vehicle.

Axkid provides car seats both with ISOFIX and seat belt attachment. Filter based on your preferred installation type here.

Yes, you can. Make sure that when you install the car seat it does not touch the seat in front of it. Once you have finished installing it, you can push back the seat in front and let it touch your car seat. Also make sure that you use the support leg correctly when installing the seat. Be very careful if you have an electrically powered car seat in front since the motors is very strong and can damage the Axkid seat.

Yes, the tether straps must always be used when installing it with ISOFIX.

Yes, you can! You can find the instructions on how to remove and fitting the covers step by step in our manuals which you find here »

The seat cover can be washed in a washing machine at 30º C on the “Gentle Cycle” programme. Do not put the cover in a dryer as this can damage the cover and the padding may separate from the fabric.

Yes, you can install the car seat in the front seat of your car. However, it is important to check the support leg and make sure that it is at an angle over 10° from the back of the seat. You can check this by ensuring that the support leg is further away from the seat than the vertical line. And don’t forget to always ensure that the airbag is turned off, this is very important!

Yes, when using the car seat rear-facing, you must always install the seat with the support leg. That’s how our car seats are tested and approved. Before installing the support leg you need to make sure that there is no storage compartment underneath the car floor. If this is the case, the lid needs to be removed and the support leg installed in that space and not on top of the storage compartment. Most car manufactures offer a storage compartment filler that also be used but please consult with your car manufacture or dealer.

You can access the manual for your Axkid car seat by scanning the QR code located on the car seat.

All manuals are also available on our website under Product manuals, where you can select your product and find the correct manual.